Energy UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is built solely for that compact lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit has become broadly used while in the business of logistic products such as minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled from the solenoid valve with the velocity managed through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Common Description
This power unit is created exclusively to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve along with the speed managed by the adjustable needle valve. Once the lift rises to a substantial positoin, however the electrical power provide is lower, the decreasing movement is managed through the manual override function.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This electrical power unit is developed solely for your huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve as well as velocity controlled by a strain compensated flow manage valve.
Power UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is developed exclusively for your massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and the pace controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power provide is cut, the decreasing motion is managed from the guide override perform.
Distinctive Notes
one. This power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned in advance of installation of the electrical power unit.
three. Viscosity from the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
four. Oil modifying is required right after the preliminary 100 operation hrs,afterwards the moment every single 3000 hrs.
5. The electrical power unit shown is built to be mounted vertically.