Material Managing Energy UNIT one
Basic Description
This energy unit is built for the fork lift business, consisting of hugely effective gear pump, DC motor, guide raise and decrease valve, tank, ect. The up and down movement are managed from the lever on the guide release valve, which is outfitted with an electric switch to activate the motor. The lowing pace is controlled from the stress compensated flow control valve.
Unique Notes
one. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean all of the hydraulic elements concerned prior to set up of the power unit.
three. Viscosity on the hydraulic oil shoud be 15~46 cst, which need to also be clean and totally free of impurities, N46 hydraulic oil is encouraged .
4. Oil altering is needed immediately after the preliminary one hundred operation hours, afterwards the moment each and every 3000 hrs.
5. The energy unit shown is made to be mounted horizontally.

Materials Handling Electrical power UNIT two
General Description
This power unit capabilities power up gravity down circuit. Activate the start off solenoid to begin the motor to lift the machine. The lowing movement is activated by the solenoid valve with all the lowering pace controlled from the strain compensated flow management valve. Products of this series is usually widely utilized in the market of logistic devices like fork lift, mini lift table, and so on.
Unique Notes
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean all of the hydraulic components concerned in advance of mounting the electrical power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which should also be clean and totally free of impurities, N46 hydraulic oil is advisable .
four. Oil modifying is required after the initial 100 operation hours,afterwards the moment just about every 3000 hours.
5. The electrical power unit need to be mounted horizontally.